Workpiece counter with table NC8125
Workpiece counter with table
NC8125
NC program for a workpiece counter. The counter is saved in a table to ensure that it is retained even when the control is switched off. At the beginning of the program, you define the desired number of repetitions.
While the program is running, the control shows the number of parts produced so far on the screen. When the specified number is reached, this is also indicated on the screen. The counter is then reset in the table.
Supported by TNC 426 from NC software no.: 280474-xx
Product type
Calculations
Tables
Milling in 3 axes (X, Y, Z)
Milling in 3 + 2 axes (X, Y, Z + inclined axes)
Milling in 5 axes (X, Y, Z + tilting axes)
Drilling
Milling-turning
Milling
NC program
Programming station
Programming station VirtualBox
Machine control
iTNC 530
TNC 426/430