Workpiece counter with QR parameter NC8130
Workpiece counter with QR parameter
NC8130
NC program for a workpiece counter. The counter is saved in a QR parameter to ensure that it is retained even when the control is switched off. At the beginning of the program, you define the desired number of repetitions.
While the program is running, the control shows the number of parts produced so far on the screen. When the specified number is reached, a message is displayed on the screen. The counter (QR parameter) is then reset to zero.
Supported by the iTNC 530 from NC software no.: 340 49x-05
Product type
iTNC 530
TNC 620
TNC 640
TNC 320
Calculations
Milling in 3 axes (X, Y, Z)
Milling in 3 + 2 axes (X, Y, Z + inclined axes)
Milling in 5 axes (X, Y, Z + tilting axes)
Drilling
Milling-turning
Milling
NC program
Programming station
Programming station VirtualBox
Machine control
TNC7